It will also let you individually control the jacks (not the usual required pair operation) and therefore let you bend the frame, if you're not careful. (Who would have thought to tap "LEVELER" 5 times would reveal a secret menu?)ĭepending on what screen you are on when you do this, you can either set the Zero (level) of the system. If you agree to accept responsibility, then the "secret menu" is displayed which gives you further options. By doing this, a warning is displayed asking if you want to continue because you can bend your frame. ![]() I only did this on my phone, so I'm not sure if it works on the touchpad in the RV. If it doesn't work on that screen, it should work on the app on your phone with a similar screen displayed. Tap 5 times on the word "Leveler" shown in the marked-up version of your picture. ![]() I called Lippert this morning with the same question. Here's how to get it to Zero (I guess what you call Calibration mode) on the Compass Connect App. Be very careful about operating any jack individually. WARNING: You can bend your RV frame if you do this wrong. Any ideas on how to get it to the calibration mode? The wifi at this RV park isn't so good. Here are a couple of pictures of my touch pad. I checked my owners manual and it doesn't list the unit that I have. That rear sensor is normally buried between the coroplast and the bottom of the trailer's floor.Ĭountry Campers - did I miss anything? (Brian has this system on his 29RS sans the CompassConnect.) Note that the the OP's Reflection does not have the OneControl Touch Panel shown in the pic below but the trailer does have a CompassConnect enabled Ground Control controller, so they should be able to level via the app in addition to the Ground Control panel. 4 Precise, motorized jacks can be operated by either the. There are two sensors, one in the Ground Control circuit board and a separate sensor that is installed aft of the axles. Automatically level and stabilize your fifth-wheel RV with this electronic leveling system. ![]() Is there an actual level that is attached to the trailer that controls the Ground Contorl module itself?That absolutely could be an issue if the trailer still won't auto level after setting it correctly. Or was that another problem not associated when one has the Ground Control system. Howard Did I see someone else have an issue on another thread where the actual level had come loose on the trailer and wasn`t recording the true level front to back to start with.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |